All comic based images, store refrences and/or commercial products are copyright to their respective owners and claim no ownership or copyright infringments due to these posting
I would like to start off by saying just about all my build photos were lost due to a crash - I do apologize. Very similar to Angrir, there was no actual measurements of this hammer within the comics so I needed to take some assumptions. I based a lot of the measurements on comic images and how it related to windows and doors as well as people. I used standard 1 1/2" wooden dowel 48 inches in length for the handle simple purchased from Home Depot and cut to 36 inches. This is where I figured just about all measurements as well as previously posted. I laid out the hammer in AutoCAD to get a final design and my plan of attach. Nul's hammer head was a little difficult to make due to the intricate angels and groves even with AutoCAD's assistance . I did originally start with Styrofoam being able to cut the angles easier and was going to smooth over the surface with a hardener. This proved to be a failure so I used foam core display boards to build the body and covered it with glue to get a extra layer between the boards and the next step. I was pleased with this process and applied fiber glassed over the entirety of the hammer head to give it strength. The next process was to Bondo over the fiberglass mat and sanded smooth till 80% of the hammer was perfectly smooth. I molded the end ring in polyester resin as with the same process of the hammer of Angrir. the handle was laid out a with a with a one ended threaded pvc fitting. I figure the approximate location of the handle in the head and drill the hole with a hole saw bit. Due to three layers of fiber glass I managed to tread the pvc fit in and glued it in place I had some extra tan fabric left over from another project and used it for the wrappings. I discolored (dirtied up) by soaking the fabric in black coffee for a few hours. The end ring was cast in polyester resin found at Wal-Mart in the auto section filling a tube I formed in a circle. After the initial build was complete I took the raw hammer and painted it with filler primer, about three coats and then final paintings was done with the Silver Rust-Oleum Hammered Spray Paint the end point was masked over and paint with Black Rust-Oleum Hammered Spray Paint. Wrapped the fabric around the end ring and where the hammer head and handle meets and bam finished
The Mystical Hammer of Nul
The Hammer of Nul fell to Earth after the Serpent called a series of hammers to awaken the Worthy. It crashed in Brazil, drawing the attention of Bruce Banner and Betty Ross. Turning into their respective Hulk forms, they investigated the crash site. The Hulk was drawn to the Hammer and was transformed into Nul, Breaker of Worlds. He warned Red She-Hulk to run before losing control and going on a rampage in a local town nearby.
He battled Spider-Woman, Ms. Marvel and the Protector. He use his hammer to knock out Protector before he reaches the ground. After the Serpent was defeated, the hammer was claimed by the Forgiven, until Valkyrie convinced them to give it to her
excerpt taken from Marvel Database